Cisco configure command

Requirement	Cisco Command
Set a console password to cisco	Router(config)#line con 0 Router(config-line)#login Router(config-line)#password cisco
Set a telnet password	Router(config)#line vty 0 4 Router(config-line)#login Router(config-line)#password cisco
Stop console timing out	Router(config)#line con 0 Router(config-line)#exec-timeout 0 0
Set the enable password to cisco	Router(config)#enable password cisco
Set the enable secret password to peter. This password overrides the enable password and is encypted within the config file	Router(config)#enable secret peter
Enable an interface	Router(config-if)#no shutdown
To disable an interface	Router(config-if)#shutdown
Set the clock rate for a router with a DCE cable to 64K	Router(config-if)clock rate 64000
Set a logical bandwidth assignment of 64K to the serial interface	Router(config-if)bandwidth 64 Note that the zeroes are not missing
To add an IP address to a interface	Router(config-if)#ip addr 10.1.1.1 255.255.255.0
To enable RIP on all 172.16.x.y interfaces	Router(config)#router rip Router(config-router)#network 172.16.0.0
Disable RIP	Router(config)#no router rip
To enable IRGP with a AS of 200, to all interfaces	Router(config)#router igrp 200 Router(config-router)#network 172.16.0.0
Disable IGRP	Router(config)#no router igrp 200
Static route the remote network is 172.16.1.0, with a mask of 255.255.255.0, the next hop is 172.16.2.1, at a cost of 5 hops	Router(config)#ip route 172.16.1.0 255.255.255.0 172.16.2.1 5
Disable CDP for the whole router	Router(config)#no cdp run
Enable CDP for he whole router	Router(config)#cdp run
Disable CDP on an interface	Router(config-if)#no cdp enable